# The amount of material for the mesh

It's required to produce a mesh with predetermined length and width, roughly square meshes from tape with predetermined width. It is necessary to calculate the total length of the tape.

It's required to produce a mesh with a predetermined length, width and roughly square meshes from a tape with a predetermined width. It is necessary to calculate the total length of the tape.
For calculation, it's necessary to know the approximate size of a single mesh. The final size will be calculated so as to have a whole number of meshes by the width and length of the tape. The mesh size is defined and calculated from the center of one tape to the center of the other, i.e. mesh gap is smaller in length and width by the tape width.

The length of the mesh along the outer perimeter
The width of the mesh along the outer perimeter
Expected distance between the centers of two neighboring tapes
Digits after the decimal point: 2
Single mesh length

Single mesh width

Number of cross tapes

Number of longitudinal tapes

Tape total length PLANETCALC, The amount of material for the mesh